Q. The correct sequence of tool materials in increasing order of their ability to retain their hot hardness is

View solution

Q. Which of the following statement is incorrect with reference of lathe cutting tools?

View solution

Q. In the relation VTn = C, the value of n for carbide tools is

View solution

Q. In up milling, the thickness of chip is

View solution

Q. The tool made of cemented carbide wear out faster at

View solution

Q. A push broach as compared to pull broach

View solution

Q. Twist drills are made of

View solution

Q. A twist drill is a

View solution

Q. The rake angle required to machine brass by high speed steel tool is

View solution

Q. A fine grained grinding wheel is used to grind hard materials.

View solution

Q. Cast iron during machining produces

View solution

Q. A single point thread cutting tool should ideally have

View solution

Q. The work or surface speed for cylindrical grinding varies from

View solution

Q. The cutting tool in a milling machine is mounted on

View solution

Q. In order to prevent tool from rubbing the work __________ on tools are provided.

View solution

Q. The silicon carbide abrasive is chiefly used for grinding

View solution

Q. Drilling is an example of

View solution

Q. A round nose tool may be fed eitner from left to right end or from right to left end of the lathe bed.

View solution

Q. When the cutting edge of the tool is dull, then during machining

View solution

Q. A drill considered as a cutting tool having zero rake, is known as a

View solution