Q. Which of the following statement is correct for orthogonal cutting system?

View solution

Q. The angle made by the face of the tool and the plane parallel to the base of cutting tool is called

View solution

Q. In case of turning, as the machining proceeds, the spindle speed must __________ with the decrease in diameter of work.

View solution

Q. The example of snag grinding is

View solution

Q. The angle between the shear plane and __________ is called shear angle.

View solution

Q. In machining soft materials, a tool with negative relief angle is used.

View solution

Q. Which of the following parameters influence the axial feed rate in centreless grinding?

View solution

Q. The lathe spindles are usually made hollow and provided with

View solution

Q. The top and sides of the table of a shaper usually have

View solution

Q. The binding material used in cemented carbide tools is

View solution

Q. In machining metals, chips break due to __________ of work material.

View solution

Q. For softer materials, the point angle of the drill is kept

View solution

Q. When the backgear is engaged in a backgeared headstock, the spindle speed reduces considerably.

View solution

Q. In continuous chip cutting, the maximum heat is taken by the cutting tool.

View solution

Q. Which of the following statement is correct regarding grinding of high carbon steel?

View solution

Q. The rear teeth of a broach

View solution

Q. High speed steel drills can be operated at about __________ the speed of high carbon steel drills.

View solution

Q. When the end of a tap is tapered for about three or four threads, it is known as a

View solution

Q. Glazing in grinding wheels can be decreased by

View solution

Q. The cutting speed is minimum while machining __________ with a high speed steel tool.

View solution