Q. Slow speed of the spindle is necessary in

View solution

Q. The hole drilled for tapping should be smaller than the tap size by twice the depth of thread.

View solution

Q. Relief angles on high speed steel tools usually vary from

View solution

Q. It is required to cut screw threads of 2 mm pitch on a lathe. The lead screw has a pitch of 6 mm. If the spindle speed is 60 r.p.m., then the speed of lead screw will be

View solution

Q. The tool life in case of a grinding wheel is the time

View solution

Q. In which of the following machine, the work is usually rotated while the drill is fed into work?

View solution

Q. In twist fluted drills, chips do not move out automatically.

View solution

Q. Mild steel during machining produces __________ chips.

View solution

Q. Up milling is also called conventional milling.

View solution

Q. Fixtures are used

View solution

Q. In ultra-sonic machining, tool is made of

View solution

Q. Ceramic tools has greater tool life than carbide tools.

View solution

Q. The rake angle of a single point cutting tool corresponds to __________ of a twist drill.

View solution

Q. As the cutting speed increases, the tool cutting forces

View solution

Q. Crater wear leads to

View solution

Q. The addition of lead, sulphur and phosphorus to low carbon steels, help to

View solution

Q. The relation between the tool life (T) in minutes and cutting speed (V) in m/min is (where n = An exponent, which depends upon the tool and workpiece, and C = A constant)

View solution

Q. The width of cutting edge of a parting-off tool varies from

View solution

Q. A tool used to withdraw a drill from the sleeve is called

View solution

Q. The cutting fluid mostly used for machining steel is

View solution