Q. The carbide tools operating at very low cutting speeds (below 30 m/min)

View solution

Q. In oblique cutting of metals, the cutting edge of the tool is

View solution

Q. The grinding of long, slender shafts or bars is usually done by

View solution

Q. In centreless grinding, work place centre will be

View solution

Q. Tool life is measured by the

View solution

Q. Soft materials can not be economically ground due to

View solution

Q. The process of removing metal by a cutter which is rotated in the same direction of travel of workpiece, is called

View solution

Q. Crater wear is mainly due to the phenomenon known as

View solution

Q. The cutting speed for drilling aluminium, brass and bronze with high speed steel drills varies from

View solution

Q. Flank wear depends upon the

View solution

Q. The tool may fail due to

View solution

Q. The operation of machining several surfaces of a workpiece simultaneously is called

View solution

Q. The abrasive recommended for grinding materials of low tensile strength is

View solution

Q. The chamfering is an operation of

View solution

Q. The hard grade grinding wheels are denoted by the letters

View solution

Q. The tailstock set over required to turn a taper on the entire length of a workpiece having diameters D and d is

View solution

Q. The angle formed by the leading edge of the land with a plane having the axis of the drill, is called

View solution

Q. A drill bit of 20 mm diameter rotating at 500 r.p.m. with a feed rate of 0.2 mm/revolution is used to drill a through-hole in a mild steel plate 20 mm thickness. The depth of cut in this drilling operation is

View solution

Q. The tail stock and the carriage of a lathe may be guided on same or different guideway.

View solution

Q. In order to achieve a specific surface finish in single point turning, the most important factor to be controlled is

View solution