Question
a.
lower chip-tool contact area and larger shear angle
b.
higher chip-tool contact area and smaller shear angle
c.
lower chip-tool contact area and smaller shear angle
d.
higher chip-tool contact area and larger shear angle
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A better machinable metal is one which gives
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. For turning small taper on long workpiece, the suitable method is
View solution
Q. In a milling operation, two side milling cutters are mounted with a desired distance between them so that both sides of a workpiece can be milled simultaneously. This set up is called
View solution
Q. The time (in minutes) for a drilling a hole is given by where h is the
View solution
Q. Crack in grinding wheel is developed due to
View solution
Q. The average cutting speed for turning mild steel with a high speed steel tool is
View solution
Q. For machining a cast iron workpiece by a high speed steel tool, the average cutting speed is
View solution
Q. The vector sum of cutting velocity and chip velocity is __________ shear velocity.
View solution
Q. For harder alloy steel, the point angle of the drill is kept
View solution
Q. An open structure of a grinding wheel is denoted by the number 1 to 8.
View solution
Q. In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be
View solution
Q. In a shaper, the metal is removed during
View solution
Q. The aluminium oxide abrasive is chiefly used for grinding
View solution
Q. In __________ operation, the chip thickness is minimum at the beginning of the cut and it reaches to the maximum when the cut terminates.
View solution
Q. In __________ operation, the cutting force is maximum when the tooth begins its cut and reduces it to minimum when the tooth leaves the work.
View solution
Q. The taper on the lathe spindle is
View solution
Q. In machining cast iron, no cutting fluid is required.
View solution
Q. In machining metals, surface roughness is due to
View solution
Q. A diamond locating pin is used in jigs and fixtures because
View solution
Q. In metal machining, the zone where the heat is generated due to friction between the moving chip and the tool face, is called
View solution
Q. The drill spindles are provided with standard taper known as
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
