Q. Flank wear is due to the abrasive action of hard mis-constituents including debris from built up edge as the work material rubs the work surface.

View solution

Q. The operation of reproduction of an outline of a template on a workpiece is called face milling.

View solution

Q. The usual value of the point angle of a drill is

View solution

Q. Buffing wheels are made of

View solution

Q. In drilling mild steel and brass, the point angle of a drill is 118°.

View solution

Q. The tail stock set over method of taper turning is preferred for

View solution

Q. The chuck preferred for quick setting and accurate centering of a job is

View solution

Q. Negative rakes are used for

View solution

Q. A bottoming tap has

View solution

Q. The enlarging of an existing circular hole with a rotating single point tool is called

View solution

Q. In the relation VTn = C, the value of n for high speed steel tools varies from 0.25 to 0.40.

View solution

Q. Glazing in grinding wheels __________ cutting capacity.

View solution

Q. The usual value of the helix angle of a drill is

View solution

Q. The cutting speed for counter-boring should be __________ that of drilling operation.

View solution

Q. Hard and tough materials like cast iron should be turned at

View solution

Q. In oblique cutting system, the cutting edge of the tool

View solution

Q. When the shear angle is small

View solution

Q. A fine grained grinding wheel is used to grind

View solution

Q. EDM machining is applied for

View solution

Q. In gear hobbing

View solution