Q. The torque transmitted by a solid shaft of diameter (D) is (where τ = Maximum allowable shear stress)

View solution

Q. When a rectangular beam is loaded transversely, the maximum compressive stress is developed on the

View solution

Q. The bending stress in a beam is __________ section modulus.

View solution

Q. When shear force at a point is zero, then bending moment is __________ at that point.

View solution

Q. When a bar is cooled to - 5°C, it will develop

View solution

Q. The limit of eccentricity is based upon no tension condition.

View solution

Q. The strain energy stored in a solid circular shaft subjected to shear stress (τ) is (where C = Modulus of rigidity for the shaft material)

View solution

Q. When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as __________ double cover butt joint.

View solution

Q. Whenever a material is loaded within elastic limit, stress is __________ strain.

View solution

Q. A load which is spread over a beam in such a manner that it varies uniformly over the whole length of abeam is called uniformly __________ load.

View solution

Q. Which of the following statement is correct?

View solution

Q. The bending moment at a point on a beam is the algebraic __________ of all the moments on either side of the point.

View solution

Q. The maximum diameter of the hole that can be punched from a plate of maximum shear stress 1/4th of its maximum crushing stress of punch, is equal to (where t = Thickness of the plate)

View solution

Q. Two closely coiled helical springs 'A' and 'B' are equal in all respects but the number of turns of spring 'A' is half that of spring 'B' The ratio of deflections in spring 'A' to spring 'B' is

View solution

Q. The deformation per unit length is called

View solution

Q. In order to know whether a column is long or short, we must know its slenderness ratio.

View solution

Q. A composite shaft consisting of two stepped portions having spring constants k1 and k2 is held between two rigid supports at the ends. Its equivalent spring constant is

View solution

Q. Resilience is the

View solution

Q. If the depth is kept constant for a beam of uniform strength, then its width will vary in proportional to (where M = Bending moment)

View solution

Q. A concentrated load is one which

View solution