Q. A body is subjected to two normal stresses 20 kN/m² (tensile) and 10 kN/m² (compressive) acting perpendicular to each other. The maximum shear stress is

View solution

Q. When a cantilever beam is loaded at its free end, the maximum compressive stress shall develop at

View solution

Q. The rivets are made from ductile material.

View solution

Q. The rectangular beam 'A' has length l, width b and depth d. Another beam 'B' has the same length and width but depth is double that of 'A'. The elastic strength of beam B will be __________ as compared to beam A.

View solution

Q. When a closely-coiled helical spring is subjected to an axial load, it is said to be under

View solution

Q. When a rectangular beam is loaded transversely, the zero stress is developed on the neutral axis.

View solution

Q. Compression members always tend to buckle in the direction of the

View solution

Q. The maximum tangential stress in a thick cylindrical shell is always __________ the internal pressure acting on the shell.

View solution

Q. A thin spherical shell of diameter (d) and thickness (t) is subjected to an internal pressure (p). The stress in the shell material is

View solution

Q. Rivets are generally specified by

View solution

Q. Principle plane is a plane on which the shear stress is

View solution

Q. For a 25 mm hole drilled in plates, the diameter of rivet shank should be

View solution

Q. A beam of uniform strength has

View solution

Q. The shear force of a simply supported beam carrying a central point load changes sign at its midpoint.

View solution

Q. In a simple bending theory, one of the assumption is that the material of the beam is isotropic. This assumption means that the

View solution

Q. The Poisson's ratio for cast iron varies from

View solution

Q. The Rankine's theory for active earth pressure is based on the assumption that

View solution

Q. The strain energy stored in a spring, when subjected to maximum load, without suffering permanent distortion, is known as

View solution

Q. An overhanging beam must overhang on both sides.

View solution

Q. The resultant stress on an inclined plane which is inclined at an angle θ to the normal cross-section of a body which is subjected to a direct tensile stress (σ) in one plane, is

View solution