Q. In order to avoid tearing off the plate at an edge, the distance from the centre of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)

View solution

Q. In a riveted joint, when the rivets in the various rows are opposite to each other, the joint is said to be

View solution

Q. The load required to produce a unit deflection in a spring is called

View solution

Q. A pressure vessel is said to be a thin shell when it is made of thin sheets.

View solution

Q. When a column is subjected to an eccentric load, the stress induced in the column will be

View solution

Q. Which of the following statement is wrong?

View solution

Q. When a shaft is subjected to a twisting moment, every cross-section of the shaft will be under

View solution

Q. A double strap butt joint with equal straps is

View solution

Q. At the neutral axis of a beam

View solution

Q. The line of intersection of the neutral layer with any normal cross-section of the beam is called neutral axis.

View solution

Q. In a thick cylindrical shell subjected to an internal pressure (p), the maximum radial stress at the inner surface of the shell is

View solution

Q. Shear strength of the welded joint for double parallel fillet is (where τ = Allowable shear stress for weld metal)

View solution

Q. The strength of the un-riveted or solid plate per pitch length is

View solution

Q. A simply supported beam is one which is supported on more than two supports.

View solution

Q. For long columns, thevalue of buckling load is __________ crushing load.

View solution

Q. A column that fails due to direct stress, is called

View solution

Q. The thermal stress __________ upon the cross-sectional area of the bar.

View solution

Q. A thin cylindrical shell of diameter (d) length (l) and thickness (t) is subjected to an internal pressure (p). The longitudinal stress in the shell is

View solution

Q. If the section modulus of a beam is increased, the bending stress in the beam will

View solution

Q. A beam encastered at both the ends is called

View solution