Q. The strength of the un-riveted or solid plate per pitch length is

View solution

Q. A simply supported beam is one which is supported on more than two supports.

View solution

Q. For long columns, thevalue of buckling load is __________ crushing load.

View solution

Q. A column that fails due to direct stress, is called

View solution

Q. The thermal stress __________ upon the cross-sectional area of the bar.

View solution

Q. A thin cylindrical shell of diameter (d) length (l) and thickness (t) is subjected to an internal pressure (p). The longitudinal stress in the shell is

View solution

Q. If the section modulus of a beam is increased, the bending stress in the beam will

View solution

Q. A beam encastered at both the ends is called

View solution

Q. The maximum shear stress is equal to the radius of Mohr's circle.

View solution

Q. A closely coiled helical spring is of mean diameter (D) and spring wire diameter (d). The spring index is the ratio of

View solution

Q. The strain energy stored in a body, when the load is gradually applied, is (where σ = Stress in the material of the body, V = Volume of the body, and E = Modulus of elasticity of the material)

View solution

Q. If the diameter of pressure vessel is 15 times the wall thickness, the vessel is said to be a thick shell.

View solution

Q. The rivets are used for __________ fastenings.

View solution

Q. A beam which is fixed at one end and free at the other is called

View solution

Q. When a body is subjected to three mutually perpendicular stresses, of equal intensity, the ratio of direct stress to the corresponding volumetric strain is known as

View solution

Q. The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called

View solution

Q. The section modulus of a rectangular section about an axis through its C.G., is

View solution

Q. The ratio of shear modulus to the modulus of elasticity for a Poisson's ratio of 0.4 will be

View solution

Q. The maximum deflection of a fixed beam of length L carrying a total load W uniformly distributed over the whole length is

View solution

Q. The pull required to tear off the plate per pitch length is (where p = Pitch of rivets, t = Thickness of plates, and σt, τ and σc = Permissible tensile, shearing and crushing stresses respectively)

View solution