Q. The maximum deflection of a fixed beam of length L carrying a total load W uniformly distributed over the whole length is

View solution

Q. The pull required to tear off the plate per pitch length is (where p = Pitch of rivets, t = Thickness of plates, and σt, τ and σc = Permissible tensile, shearing and crushing stresses respectively)

View solution

Q. When a beam is subjected to bending moment, the stress at any point is __________ the distance of the point from the neutral axis.

View solution

Q. The torsional rigidity of a shaft is given by

View solution

Q. The unit of strain is

View solution

Q. The maximum deflection of a cantilever beam of length L with a point load W at the free end is

View solution

Q. The maximum bending moment of a cantilever beam of length l and carrying a uniformly distributed load of w per unit length lies at the middle of its length.

View solution

Q. Young's modulus may be defined as the ratio of

View solution

Q. The maximum shear stress in a thin cylindrical shell subjected to internal pressure p is

View solution

Q. When a shaft, is subjected to torsion, the shear stress induced in the shaft varies from

View solution

Q. The maximum bending moment for a simply supported beam with a gradually varying load from zero at both ends and w per metre at the centre, lies at the centre of a beam.

View solution

Q. A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa on a plane at right angles to the former. It is also subjected to a shear stress of 400 MPa on the same planes. The maximum shear stress will be

View solution

Q. A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to

View solution

Q. The factor of safety is always more than unity.

View solution

Q. Mohr's circle is used to determine the stresses on an oblique section of a body subjected to

View solution

Q. The proof resilience is the maximum strain energy which can be stored in a body.

View solution

Q. The maximum shear stress developed in a beam of rectangular section is __________ the average shear stress.

View solution

Q. The strength of a riveted joint is equal to the

View solution

Q. The neutral axis of the symmetrical beam does not pass through the centroid of the beam.

View solution

Q. The Poisson's ratio for steel varies from

View solution