Q. A body is subjected to a direct tensile stress (σ) in one plane. The shear stress is maximum at a section inclined at __________ to the normal of the section.

View solution

Q. The bending moment on a section is maximum where shear force is

View solution

Q. The springs in cars are used to store strain energy.

View solution

Q. The unit of Young's modulus is same as that of stress.

View solution

Q. According to Euler's column theory, the crippling load for a column of length (L) with one end fixed and the other end hinged, is

View solution

Q. The pull required to shear off a rivet, in double shear, per pitch length is

View solution

Q. Lame's theory is associated with

View solution

Q. The ductility of the material __________ with the decrease in percentage elongation of a specimen under tensile test.

View solution

Q. The shear force diagram of a cantilever beam of length l and carrying a uniformly distributed load of w per unit length will be

View solution

Q. Whenever some external system of forces acts on a body, it undergoes some deformation. As the body undergoes some deformation, it sets up some resistance to the deformation. This resistance per unit area to deformation, is called

View solution

Q. The longitudinal stress in a riveted cylindrical shell of diameter (d), thickness (t) and subjected to an internal pressure (p) is

View solution

Q. Two solid shafts 'A' and 'B' are made of the same material. The shaft 'A' is of 50 mm diameter and shaft 'B' is of 100 mm diameter. The strength of shaft 'B' is __________ as that of shaft A.

View solution

Q. In calculating the strength of a riveted joint in tearing, shearing and crushing, the

View solution

Q. The tensile test is carried on __________ materials.

View solution

Q. If percentage elongation of a certain specimen made of a material 'A' under tensile test is 30% and the percentage elongation of a specimen with same dimensions made of another material 'B' is 40%, then material 'B' is more ductile than material 'A'.

View solution

Q. A fixed beam is one which is fixed at __________ of its ends.

View solution

Q. Factor of safety is defined as the ratio of

View solution

Q. The value of equivalent length is taken to be half of the actual length of a column with one end fixed and the other end free.

View solution

Q. The strain energy stored in a hollow circular shaft of outer diameter (D) and inner diameter (d) subjected to shear stress is

View solution

Q. Fatigue test is carried out for

View solution