Q. A fixed beam is one which is fixed at __________ of its ends.

View solution

Q. Factor of safety is defined as the ratio of

View solution

Q. The value of equivalent length is taken to be half of the actual length of a column with one end fixed and the other end free.

View solution

Q. The strain energy stored in a hollow circular shaft of outer diameter (D) and inner diameter (d) subjected to shear stress is

View solution

Q. Fatigue test is carried out for

View solution

Q. The section modulus (Z) of a beam is given by

View solution

Q. Every direct stress is always accompanied by a strain in its own direction and an opposite kind of strain in every direction, at right angles to it. Such a strain is known as

View solution

Q. The shear force of a cantilever beam of length l and carrying a gradually varying load from zero at the free end and w per unit length at the fixed end is __________ at the fixed end.

View solution

Q. When a rectangular beam is loaded transversely, the maximum tensile stress is developed on the

View solution

Q. The compressive strength of brittle materials is __________ its tensile strength.

View solution

Q. In spring balances, the spring is used

View solution

Q. According to Euler's column theory, the crippling load of a column is given by p = π2 EI/Cl2. In the Euler's formula, the value of C for a column with both ends fixed is 4.

View solution

Q. The centre to centre distance, between two consecutive rivets in a row, is called

View solution

Q. The buckling load for a given column depends upon

View solution

Q. A continuous beam is one which is

View solution

Q. When a body is subjected to two equal and opposite pulls, as a result of which the body tends to extend its length, the stress and strain induced is

View solution

Q. The hoop stress in a riveted cylindrical shell of diameter (d), thickness (t) and subjected to an internal pressure (p) is (where η = Efficiency of the riveted joint)

View solution

Q. The torsional rigidity of a shaft is expressed by the torque required to produce a twist of one radian per unit length of a shaft.

View solution

Q. The stress developed in the material without any permanent set is called

View solution

Q. For riveting, the size of hole drilled in plates is __________ shank diameter of rivet.

View solution