Q. When a rectangular beam is loaded transversely, the maximum tensile stress is developed on the

View solution

Q. The compressive strength of brittle materials is __________ its tensile strength.

View solution

Q. In spring balances, the spring is used

View solution

Q. According to Euler's column theory, the crippling load of a column is given by p = π2 EI/Cl2. In the Euler's formula, the value of C for a column with both ends fixed is 4.

View solution

Q. The centre to centre distance, between two consecutive rivets in a row, is called

View solution

Q. The buckling load for a given column depends upon

View solution

Q. A continuous beam is one which is

View solution

Q. When a body is subjected to two equal and opposite pulls, as a result of which the body tends to extend its length, the stress and strain induced is

View solution

Q. The hoop stress in a riveted cylindrical shell of diameter (d), thickness (t) and subjected to an internal pressure (p) is (where η = Efficiency of the riveted joint)

View solution

Q. The torsional rigidity of a shaft is expressed by the torque required to produce a twist of one radian per unit length of a shaft.

View solution

Q. The stress developed in the material without any permanent set is called

View solution

Q. For riveting, the size of hole drilled in plates is __________ shank diameter of rivet.

View solution

Q. When a bar is subjected to a change of temperature and its deformation is prevented, the stress induced in the bar is

View solution

Q. A shear stress across a plane, is always accompanied by a balancing shear stress across the plane and normal to it.

View solution

Q. The bending moment diagram for a simply supported beam loaded in its centre is

View solution

Q. A load which acts at a point on a beam is not called uniformly distributed load.

View solution

Q. The rectangular beam 'A ' has length l, width b and depth d. Another beam 'B' has the same width and depth but length is double that of 'A'. The elastic strength of beam 'B' will be __________ as compared to beam A.

View solution

Q. A tensile test is performed on a round bar. After fracture, it has been found that the diameter remains approximately same at fracture. The material under test was

View solution

Q. In a simply supported beam carrying a uniformly distributed load w per unit length, the point of contraflexure

View solution

Q. Modulus of rigidity may be defined as the ratio of

View solution