Q. The force exerted by a jet of water (in a direction normal to flow) impinging on a fixed plate inclined at an angle θ with the jet is

View solution

Q. The maximum number of jets, generally, employed in an impulse turbine without jet interference are

View solution

Q. In a reciprocating pump, air vessels are fitted to the suction pipe and delivery pipe close to the cylinder of the pump.

View solution

Q. Discharge (Q) of a centrifugal pump is given by (where D = Diameter of impeller at inlet, b = Width of impeller at inlet, and Vf = Velocity of flow at inlet)

View solution

Q. A centrifugal pump will start delivering liquid only when the pressure rise in the impeller is equal to the

View solution

Q. When the speed of the pump increases, its net positive suction head (NPSH) requirement decreases.

View solution

Q. The speed of a turbine runner is

View solution

Q. Discharge of a centrifugal pump is (where N = Speed of the pump impeller)

View solution

Q. In a reaction turbine, the draft tube is used

View solution

Q. The power produced by the reaction turbine is __________ to the head of water.

View solution

Q. In an inward flow reaction turbine

View solution

Q. The working of which of the following hydraulic units is based on Pascal's law?

View solution

Q. The hydraulic efficiency of a reaction turbine, is the ratio of

View solution

Q. In order to avoid cavitation in centrifugal pumps

View solution

Q. A hydraulic intensifier is a device used to increase the intensity of pressure of water by means of energy available from a large quantity of water at a low pressure.

View solution

Q. By fitting an air vessel to the reciprocating pump, there is always a saving of work done and subsequently saving of power.The saving in case of a double acting reciprocating pump is

View solution

Q. In a reciprocating pump, air vessels are used to

View solution

Q. In a Francis turbine, the pressure at inlet is __________ that at outlet.

View solution

Q. If the ratio's of the corresponding forces acting at corresponding points are equal, then the model and the prototype are said to have.

View solution

Q. A Pelton wheel working under a constant head and discharge, has maximum efficiency when the speed ratio is

View solution