Question
a.
indicated power
b.
brake power
c.
frictional power
d.
none of these
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The actual power supplied by the engine crankshaft is called
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The draught produced by a steam jet issuing from a nozzle placed in the chimney is called
View solution
Q. The chimney draught varies with
View solution
Q. Benson boiler requires
View solution
Q. The high pressure and low pressure cylinders in a Tandem type compound engine are regarded as having cranks
View solution
Q. The amount of water evaporated or steam produced in kg per kg of fuel burnt is known as power of a boiler.
View solution
Q. The fire tubes in a Cochran boiler usually have __________ diameter.
View solution
Q. Cut-off governing as compared to throttle governing is
View solution
Q. A compound steam engine in which piston rods of high pressure and low pressure cylinders ' are attached to two different cranks set at 180° to each other, is called
View solution
Q. The heat balance sheet for the boiler shows the
View solution
Q. The performance of a boiler is measured by the
View solution
Q. The evaporative capacity of a boiler is defined as the evaporation of 15.653 kg of water per hour from and at 100° C.
View solution
Q. The maximum heat loss is a boiler occurs due to
View solution
Q. For maximum discharge through a chimney, the temperature of flue gases inside the chimney should the slightly more than the atmospheric temperature.
View solution
Q. The internal flue tubes of a Lancashire boiler are reduced in diameter at the back to provide access to the lower part of the boiler.
View solution
Q. A device in which some portion of waste heat of flue gases is recovered to heat the air before it passes to the furnace for combustion purpose, is knwon as
View solution
Q. In a fire tube boiler, the water is contained inside the tubes which are surrounded by flames and hot gases from outside.
View solution
Q. Steam engines are called external combustion engines.
View solution
Q. The diagram factor is the ratio of the
View solution
Q. By compounding the expansion of steam in two or more cylinders, the length of stroke
View solution
Q. The velocity of flue gases (V) through the chimney under a static draught of(H') metres is given by
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!