Question

The clearance in the engine cylinder

a.

increases the mean effective pressure

b.

increases the workdone

c.

decreases the efficiency of the engine

d.

all of these

Posted under Mechanical Engineering

Answer: (d).all of these

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The clearance in the engine cylinder

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Which of the following is not a boiler mounting?

Q. The function of a D-slide valve is to exhaust steam from the cylinder at proper moment.

Q. The mechanical draught produces more draught than natural draught.

Q. The water tube boilers produce steam at a __________ pressure than that of fire tube boilers.

Q. The mechanical draught __________ with the amount of smoke.

Q. When the expansion of steam is carried out in a single cylinder and then exhausted into the atmosphere or a condenser, the engine is said to be a simple steam engine.

Q. In a Tandem type compound engine, the high pressure and low pressure cylinders

Q. Lancashire boiler is a stationary fire tube boiler.

Q. Lancashire boiler is used where working pressure and power required are

Q. The amount of water evaporated or steam produced in kg per kg of fuel burnt is termed as evaporative capacity of a boiler.

Q. In a compound steam engine, the temperature range per cylinder is reduced, with corresponding reduction in the condensation.

Q. Willian's law holds good for throttle-governed engine, but not for cut-off governed engine.

Q. Which of the following is required for a steam condensing plant ?

Q. The missing quantity is mainly due to cylinder condensation and a small amount of steam leakage past the valves and piston.

Q. There is always some steam left in the clearance space from the previous stroke. This steam left in the clearance space is called

Q. The ratio of the volume at cut-off to the swept volume is called

Q. The factor of evaporation for all boilers is always

Q. The ratio of the actual vacuum to the ideal vacuum in a condenser is called

Q. The draught (in mm of water), for maximum discharge of flue gases through the chimney, is given by (where H = Height ot the chimney in metres, and T1 = Absolute temperature of air outside the chimney in K)

Q. An air preheater

Recommended Subjects

Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!