Question
a.
d
b.
1.5 d
c.
2 d
d.
2.5 d
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The value of stress concentration factor depends upon
View solution
Q. The sleeve or muff coupling is designed as a
View solution
Q. A sliding bearing in which the working surfaces are completely separated from each other by lubricant is called zero film bearing.
View solution
Q. Screws used for power transmission should have
View solution
Q. The number of rivets in shear shall be equal to the number of rivets in crushing.
View solution
Q. When bevel gears connect two shafts whose axes intersect at an angle greater than a right angle and one of the bevel gears has a pitch angle of 90°, then they are known as
View solution
Q. The toughness of a material __________ when it is heated.
View solution
Q. The number of slots in a 25 mm castle nut is
View solution
Q. A screw is said to be over hauling screw, if its efficiency is
View solution
Q. The application of third type levers is found in
View solution
Q. For unequal width of butt straps, the thickness of butt straps are
View solution
Q. A locking device in which the bottom cylindrical portion is recessed to receive the tip of the locking set screw, is called
View solution
Q. Slenderness ratio is the ratio of
View solution
Q. A crankshaft is a __________ shaft.
View solution
Q. According to Indian standard specifications, 100 H6/g5 means that the
View solution
Q. A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where σ = Stress for a plate with no hole i.e. nominal stress)
View solution
Q. In second type of levers,
View solution
Q. Soderberg relation is based on __________ of the material whereas all other failure relation for dynamic loading are based on ultimate strength of the material.
View solution
Q. In a flange coupling, the flanges are coupled together by means of
View solution
Q. A transmission shaft includes
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
