Q. According to Indian standard specifications, 100 H6/g5 means that the

View solution

Q. A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where σ = Stress for a plate with no hole i.e. nominal stress)

View solution

Q. In second type of levers,

View solution

Q. Soderberg relation is based on __________ of the material whereas all other failure relation for dynamic loading are based on ultimate strength of the material.

View solution

Q. In a flange coupling, the flanges are coupled together by means of

View solution

Q. A transmission shaft includes

View solution

Q. According to I.B.R., shearing resistance required to shear off the rivet per pitch length (in double shear) is (where n = Number of rivets per pitch length)

View solution

Q. Which of the following material has the maximum ductility?

View solution

Q. When a bolt is subjected to shock loading, the resilience of the bolt should be considered in order to prevent breakage at the

View solution

Q. In order to obtain the bolts of uniform strength, an axial hole is drilled through the head as far as the threaded portion such that the area of shank becomes equal to the root area of the thread.

View solution

Q. An open belt drive is used when

View solution

Q. In unilateral system of tolerance, the tolerance is allowed on

View solution

Q. The velocity of sliding __________ the distance of the point of contact from the pitch point.

View solution

Q. A column is known as a long column if the slenderness ratio is

View solution

Q. Circumferential joint in boilers is used to get the required length of a boiler.

View solution

Q. The ball bearings are provided with a cage

View solution

Q. When screw threads are to be used in a situation where power is being transmitted in one direction only, then the screw threads suitable for this will be

View solution

Q. The load cup of a screw jack is made separate from the head of the spindle to

View solution

Q. Two shafts A and B under pure torsion are of identical length and identical weight and are made of the same material. The shaft A is solid and the shaft B is hollow. We can say that

View solution

Q. The centre distance between two meshing involute gears is equal to

View solution