Q. In unilateral system of tolerance, the tolerance is allowed on

View solution

Q. The velocity of sliding __________ the distance of the point of contact from the pitch point.

View solution

Q. A column is known as a long column if the slenderness ratio is

View solution

Q. Circumferential joint in boilers is used to get the required length of a boiler.

View solution

Q. The ball bearings are provided with a cage

View solution

Q. When screw threads are to be used in a situation where power is being transmitted in one direction only, then the screw threads suitable for this will be

View solution

Q. The load cup of a screw jack is made separate from the head of the spindle to

View solution

Q. Two shafts A and B under pure torsion are of identical length and identical weight and are made of the same material. The shaft A is solid and the shaft B is hollow. We can say that

View solution

Q. The centre distance between two meshing involute gears is equal to

View solution

Q. Which of the following statement is wrong ?

View solution

Q. In a flange coupling, the thickness of flanges is taken as one-half the diameter of shaft.

View solution

Q. In a hydrodynamic lubricated bearing

View solution

Q. Which of the following statement is correct for gears?

View solution

Q. A flanged pipe joint will be a leak-proof joint, if the circumferential pitch of the bolts is (where d = Diameter of bolt hole)

View solution

Q. Stress concentration is caused due to

View solution

Q. The resistance to fatigue of a material is measured by

View solution

Q. The metal suitable for bearings subjected to light loads is

View solution

Q. A connecting rod subjected to an axial load may buckle in the plane perpendicular to the plane of motion of the connecting rod.

View solution

Q. Which of the following is an antifriction bearing?

View solution

Q. A connecting rod is four times strong in buckling about Y-axis than about X-axis.

View solution