Q. Which of the following statement is wrong ?

View solution

Q. In a flange coupling, the thickness of flanges is taken as one-half the diameter of shaft.

View solution

Q. In a hydrodynamic lubricated bearing

View solution

Q. Which of the following statement is correct for gears?

View solution

Q. A flanged pipe joint will be a leak-proof joint, if the circumferential pitch of the bolts is (where d = Diameter of bolt hole)

View solution

Q. Stress concentration is caused due to

View solution

Q. The resistance to fatigue of a material is measured by

View solution

Q. The metal suitable for bearings subjected to light loads is

View solution

Q. A connecting rod subjected to an axial load may buckle in the plane perpendicular to the plane of motion of the connecting rod.

View solution

Q. Which of the following is an antifriction bearing?

View solution

Q. A connecting rod is four times strong in buckling about Y-axis than about X-axis.

View solution

Q. In designing a sleeve coupling, length of the sleeve is taken as (where d = Diameter of the shaft)

View solution

Q. The difference between the tooth space and the tooth thickness as measured on the pitch circle, is called

View solution

Q. When a load W is suddenly applied to a bar of weight W1, the stress induced in the bar will increase with the increase in weight W1.

View solution

Q. The endurance limit for a mirror polished material will be __________ as compared to unpolished material.

View solution

Q. A sliding bearing which operates without any lubricant present, is called

View solution

Q. The material used for brake lining should have __________ coefficient of friction.

View solution

Q. A steel containing more than 0.8% carbon is known as eutectoid steel.

View solution

Q. In leaf springs, the longest leaf is known as

View solution

Q. The taper on cotter varies from

View solution