Q. The dedendum circle diameter is equal to (where φ = Pressure angle)

View solution

Q. The rivet head used for boiler plate riveting is usually

View solution

Q. A single strap butt joint is always in __________ shear.

View solution

Q. 18/8 steel contains

View solution

Q. The module in the reciprocal of diametral pitch.

View solution

Q. The velocity factor for carefully cut gears operating at velocities upto __________ is equal to 4.5/4.5 + v.

View solution

Q. Euler's formula for a mild steel column is not valid if the slenderness ratio is

View solution

Q. The standard length of the shaft is

View solution

Q. According to I.B.R., when the thickness of boiler shell (t) is greater than 8 mm, then the diameter of rivet hole (d) is obtained by

View solution

Q. When the shaft rotates in anticlockwise direction at slow speed in a bearing, it will

View solution

Q. A taper key which fits half in the key way of the hub and half in the key way of shaft, is known as

View solution

Q. A metal pipe of 1 m diameter contains a fluid having a pressure of 1 N/mm². If the permissible tensile stress in the metal is 20 N/mm², then the thickness of the metal required for making the pipe will be

View solution

Q. A tangent key is provided in pairs at right angles and each key is to withstand torsion in one direction only.

View solution

Q. When the speed of belt increases,

View solution

Q. According to law of gearing, the common normal at the point of contact between a pair of teeth must always pass through the pitch point.

View solution

Q. An involute pinion and gear are in mesh. If both have the same size of addendum, then there will be interference between the

View solution

Q. When bevel gears having equal teeth and equal pitch angles connect two shafts whose axes intersect at right angle, then they are known as

View solution

Q. A sliding bearing which can support steady loads without any relative motion between the journal and the bearing, is called

View solution

Q. In case of pressure vessels having closed ends, the fluid pressure induces

View solution

Q. A machine part subjected to __________ is called a strut.

View solution