Q. When the shaft rotates in anticlockwise direction at slow speed in a bearing, it will

View solution

Q. A taper key which fits half in the key way of the hub and half in the key way of shaft, is known as

View solution

Q. A metal pipe of 1 m diameter contains a fluid having a pressure of 1 N/mm². If the permissible tensile stress in the metal is 20 N/mm², then the thickness of the metal required for making the pipe will be

View solution

Q. A tangent key is provided in pairs at right angles and each key is to withstand torsion in one direction only.

View solution

Q. When the speed of belt increases,

View solution

Q. According to law of gearing, the common normal at the point of contact between a pair of teeth must always pass through the pitch point.

View solution

Q. An involute pinion and gear are in mesh. If both have the same size of addendum, then there will be interference between the

View solution

Q. When bevel gears having equal teeth and equal pitch angles connect two shafts whose axes intersect at right angle, then they are known as

View solution

Q. A sliding bearing which can support steady loads without any relative motion between the journal and the bearing, is called

View solution

Q. In case of pressure vessels having closed ends, the fluid pressure induces

View solution

Q. A machine part subjected to __________ is called a strut.

View solution

Q. The yield point in static loading is __________ as compared to fatigue loading.

View solution

Q. The contact ratio is the ratio of

View solution

Q. The bearing characteristic number is given by (where p = Bearing pressure on the projected bearing area, Z = Absolute viscosity of the lubricant, and N = Speed of the journal)

View solution

Q. The cracks in helical springs used in railway carriages usually start on the inner side of the coil because of the fact that

View solution

Q. In a marine flange coupling, the thickness of flange is taken as

View solution

Q. The wire ropes make contact at

View solution

Q. The metal suitable for bearings subjected to heavy loads is

View solution

Q. The V-belts are particularly suitable for __________ drives.

View solution

Q. For hardening alloy steels and high speed steels, they are heated to

View solution