Question
a.
it is subjected to a higher stress than the outer side
b.
it is subjected to a higher cyclic loading than the outer side
c.
it is more stretched than the outer side during the manufacturing process
d.
it has a lower curvature than the outer side
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The cracks in helical springs used in railway carriages usually start on the inner side of the coil because of the fact that
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In a marine flange coupling, the thickness of flange is taken as
View solution
Q. The wire ropes make contact at
View solution
Q. The metal suitable for bearings subjected to heavy loads is
View solution
Q. The V-belts are particularly suitable for __________ drives.
View solution
Q. For hardening alloy steels and high speed steels, they are heated to
View solution
Q. An universal coupling is used to connect two shafts
View solution
Q. Which one of the following is a positive drive?
View solution
Q. Two closely coiled helical springs with stiffnesses k1 and k2 respectively are connected in series. The stiffness of an equivalent spring is given by
View solution
Q. The period during which the cam follower remains at rest, when cam moves, is known as
View solution
Q. The flank of the tooth is the
View solution
Q. The included angle for the British Association thread is
View solution
Q. If a bearing is designated by the number 305, it means that the bearing is of
View solution
Q. Tapered roller bearings can take
View solution
Q. In order to remove internal stresses produced by hardening the steel, the process usually adopted is
View solution
Q. A pressure vessel is said to be a thin shell, if the ratio of wall thickness to its diameter is equal to 1/10.
View solution
Q. A bolt of uniform strength can be developed by
View solution
Q. The ratio of endurance limit in shear to the endurance limit in flexure is
View solution
Q. The lower deviation is the algebraic difference between the
View solution
Q. When plates are fastened by a rivet, the holes in the plates should be made by punching and reaming.
View solution
Q. When carbon in the cast iron is principally in the form of graphite, the cast iron will be of
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
