Question
a.
light series whose bore is 5 mm
b.
light series whose bore is 25 mm
c.
medium series whose bore is 5 mm
d.
medium series whose bore is 25 mm
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. If a bearing is designated by the number 305, it means that the bearing is of
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Tapered roller bearings can take
View solution
Q. In order to remove internal stresses produced by hardening the steel, the process usually adopted is
View solution
Q. A pressure vessel is said to be a thin shell, if the ratio of wall thickness to its diameter is equal to 1/10.
View solution
Q. A bolt of uniform strength can be developed by
View solution
Q. The ratio of endurance limit in shear to the endurance limit in flexure is
View solution
Q. The lower deviation is the algebraic difference between the
View solution
Q. When plates are fastened by a rivet, the holes in the plates should be made by punching and reaming.
View solution
Q. When carbon in the cast iron is principally in the form of graphite, the cast iron will be of
View solution
Q. A shoe brake is commonly used in railway trains.
View solution
Q. A circular shaft can transmit a torque of 5 kN-m. If the torque is reduced to 4 kN-m, then the maximum value of bending moment that can be applied to the shaft is
View solution
Q. The design of pin of a rocker arm of an I.C. engine is based on
View solution
Q. For a shaft diameter of 100 mm, the number of bolts in a flange coupling should be
View solution
Q. A wood-ruff key is
View solution
Q. In a V-belt drive, the belt makes contact at the bottom of the groove of the pulley.
View solution
Q. According to Indian standards, a bolt thread of 6 mm size of coarse pitch and with allowance on the threads and normal tolerance grade is designated as
View solution
Q. According to maximum normal stress theory, the maximum normal stress in the shaft is
View solution
Q. When a beam of rectangular cross-section of width b and depth d, is subjected to a shear force F, the maximum shear stress induced will be
View solution
Q. In designing a connecting rod, it is considered like __________ for buckling about Y-axis.
View solution
Q. A steel containing __________ 0.8% carbon is known as hypo-eutectoid steel.
View solution
Q. A pressure vessel is said to be a thick shell, if the ratio of wall thickness to its diameter is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
