Question
a.
1 kN-m
b.
2 kN-m
c.
3 kN-m
d.
4 kN-m
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A circular shaft can transmit a torque of 5 kN-m. If the torque is reduced to 4 kN-m, then the maximum value of bending moment that can be applied to the shaft is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The design of pin of a rocker arm of an I.C. engine is based on
View solution
Q. For a shaft diameter of 100 mm, the number of bolts in a flange coupling should be
View solution
Q. A wood-ruff key is
View solution
Q. In a V-belt drive, the belt makes contact at the bottom of the groove of the pulley.
View solution
Q. According to Indian standards, a bolt thread of 6 mm size of coarse pitch and with allowance on the threads and normal tolerance grade is designated as
View solution
Q. According to maximum normal stress theory, the maximum normal stress in the shaft is
View solution
Q. When a beam of rectangular cross-section of width b and depth d, is subjected to a shear force F, the maximum shear stress induced will be
View solution
Q. In designing a connecting rod, it is considered like __________ for buckling about Y-axis.
View solution
Q. A steel containing __________ 0.8% carbon is known as hypo-eutectoid steel.
View solution
Q. A pressure vessel is said to be a thick shell, if the ratio of wall thickness to its diameter is
View solution
Q. The radial stress across the thickness of a thick cylinder is maximum at the inner surface and zero at the outer surface.
View solution
Q. The diameter of the rivet hole is usually __________ the nominal diameter of the rivet.
View solution
Q. The resilience of a bolt may be increased by
View solution
Q. In worm, gears, pitch lead angle is
View solution
Q. In worm gears, the pressure angle is half the angle between two inclined faces in axial plane.
View solution
Q. For crank shaft bearings, the ratio of the length of the journal to its diameter is less than unity.
View solution
Q. Lewis equation in gears is used to find the
View solution
Q. In order to determine the stresses in a thin cylinder due to an internal pressure, it is assumed that
View solution
Q. All stresses produced in a belt are
View solution
Q. An elastic bar is fixed at the upper end and loaded at the lower end by a falling weight. The shock load produced can be reduced by
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
