Question
a.
increasing the length of bar
b.
decreasing the cross-sectional area of the bar
c.
decreasing the modulus of elasticity of the bar
d.
all of the above
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. An elastic bar is fixed at the upper end and loaded at the lower end by a falling weight. The shock load produced can be reduced by
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The ratio of driving tensions in V-belt drives is __________ flat belt drives.
View solution
Q. A shaft is designed on the basis of rigidity and stiffness.
View solution
Q. Which of the following spring is used in mechanical wrist watch?
View solution
Q. In helical bevel gearing, the axes of shafts are __________ and the teeth are curved.
View solution
Q. When the connected members are very yielding (soft gasket) as compared to the bolt, then the resultant load on the bolt will be equal to the
View solution
Q. Which one of the following loading is considered for the design of axles?
View solution
Q. The shear stress in a beam varies from zero at the outer fibres to a maximum at the neutral surface.
View solution
Q. A basic hole is one whose
View solution
Q. In a flange coupling, the keys are staggered at __________ along the circumference of the shafts in order to divide the weakening effect caused by key ways.
View solution
Q. The major diameter of a screw thread is also known as core or root diameter.
View solution
Q. The initial tension (in newtons) in a bolt used for making a fluid tight joint like steam engine cover joints, is calculated by the relation (where d = Nominal diameter of bolt in mm)
View solution
Q. The property of a material which enables it to be drawn into wires with the application of a tensile force, is called
View solution
Q. The helix angle for single helical gears ranges from
View solution
Q. In order to withstand resistance to wear, the best profile of gear is
View solution
Q. Which of the following has threads at both ends?
View solution
Q. The ratio of the ultimate stress to the design stress is known as
View solution
Q. According to Indian standards, the diameter of rivet hole is made larger than the basic size of rivet by
View solution
Q. The cam follower extensively used in air-craft engines is
View solution
Q. The minor diameter of a screw thread is also known as outside or nominal diameter.
View solution
Q. The effective stress in wire ropes during normal working is equal to the stress due to
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
