Q. The radial stress across the thickness of a thick cylinder is maximum at the inner surface and zero at the outer surface.

View solution

Q. The diameter of the rivet hole is usually __________ the nominal diameter of the rivet.

View solution

Q. The resilience of a bolt may be increased by

View solution

Q. In worm, gears, pitch lead angle is

View solution

Q. In worm gears, the pressure angle is half the angle between two inclined faces in axial plane.

View solution

Q. For crank shaft bearings, the ratio of the length of the journal to its diameter is less than unity.

View solution

Q. Lewis equation in gears is used to find the

View solution

Q. In order to determine the stresses in a thin cylinder due to an internal pressure, it is assumed that

View solution

Q. All stresses produced in a belt are

View solution

Q. An elastic bar is fixed at the upper end and loaded at the lower end by a falling weight. The shock load produced can be reduced by

View solution

Q. The ratio of driving tensions in V-belt drives is __________ flat belt drives.

View solution

Q. A shaft is designed on the basis of rigidity and stiffness.

View solution

Q. Which of the following spring is used in mechanical wrist watch?

View solution

Q. In helical bevel gearing, the axes of shafts are __________ and the teeth are curved.

View solution

Q. When the connected members are very yielding (soft gasket) as compared to the bolt, then the resultant load on the bolt will be equal to the

View solution

Q. Which one of the following loading is considered for the design of axles?

View solution

Q. The shear stress in a beam varies from zero at the outer fibres to a maximum at the neutral surface.

View solution

Q. A basic hole is one whose

View solution

Q. In a flange coupling, the keys are staggered at __________ along the circumference of the shafts in order to divide the weakening effect caused by key ways.

View solution

Q. The major diameter of a screw thread is also known as core or root diameter.

View solution