Question
a.
a taper key which fits half in the key way of hub and half in the key way of shaft
b.
a taper key which fits in a key way of the hub and is flat on the shaft
c.
a taper key which fits in a key way of the hub and the bottom of the key is shaped to fit the curved surface of the shaft
d.
provided in pairs at right angles and each key is to withstand torsion in one direction only
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A hollow saddle key is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Pitch point of a cam is
View solution
Q. When two parallel and coplaner shafts are connected by gears having teeth parallel to the axis of the shaft, the arrangement is known as spiral gearing.
View solution
Q. A screw is specified by its
View solution
Q. The wear load should be __________ the dynamic load.
View solution
Q. The velocity factor for ordinary cut gears operating at velocities upto 12.5 m/s is equal to
View solution
Q. The property of a bearing material which has the ability to accomodate small particles of dust, grit etc. without scoring the material of the journal, is called
View solution
Q. The shock resistance of steel is increased by adding
View solution
Q. The ratio of driving tensions for flat belts, neglecting centrifugal tension, is (where T1, and T2 = Tensions on the tight and slack sides of belt respectively, μ = Coefficient of friction, between the belt and pulley, and θ = Angle of contact)
View solution
Q. A flange coupling is a type of rigid coupling.
View solution
Q. The strength of the un-riveted plate (P) per pitch length is equal to
View solution
Q. Two shafts of the same length and material are joined in series. If the ratio of their diameters is 2, then the ratio of their angles of twist will be
View solution
Q. Wahl's stress factor __________ very rapidly as the spring index decreases.
View solution
Q. For circumferential joint in boilers, the type of joint used is
View solution
Q. In cyclic loading, stress concentration is more serious in
View solution
Q. For a square key made of mild steel, the shear and crushing strength are related as
View solution
Q. According to Rankine's theory, the failure occurs at a point in a member
View solution
Q. The dedendum is the radial distance from the
View solution
Q. In a steam engine, the valve rod is connected to an eccentric rod by means of
View solution
Q. In helical gears, the distance parallel to the axis, between similar faces of adjacent teeth, is called
View solution
Q. Which of the following property is desirable in parts subjected to shock and impact loads?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
