Q. The cam follower generally used in automobile engines is

View solution

Q. A closely coiled helical spring is acted upon by an axial force. The maximum shear stress developed in the spring is τ . The half of the length of the spring if cut off and the remaining spring is acted upon by the same axial force. The maximum shear stress in the spring in new condition will be

View solution

Q. The malleable material should be plastic but is not essential to be so strong.

View solution

Q. The temperature at which the new grains are formed in the metal is known as

View solution

Q. Deep groove ball bearings are used for

View solution

Q. The shear modulus of resilience is proportional to

View solution

Q. In a sawn nut, a slot is cut about half way through the nut and a small screw is tightened between the nut and the bolt in order to produce more friction.

View solution

Q. When a load W is applied suddenly on a bar of cross-sectional area A, the stress induced in the bar will be

View solution

Q. In helical gears, the distance between similar faces of adjacent teeth along a helix on the pitch cylinders normal to the teeth, is called

View solution

Q. The longitudinal joint in boilers is used to get the required

View solution

Q. The Lewis equation for gear tooth with involute profile predicts the static load capacity of cantilever beam of uniform strength.

View solution

Q. A basic shaft is one whose

View solution

Q. When the effort is in between the fulcrum and load, the lever is said to be of third type.

View solution

Q. While designing a screw in a screw jack against buckling failure, the end conditions for the screw are taken as

View solution

Q. When a closely coiled helical spring is subjected to a couple about its axis, the stress induced in the wire material of the spring is

View solution

Q. In a journal bearing, the load on the bearing is __________ to the axis of the journal.

View solution

Q. An imaginary circle which by pure rolling action gives the same motion as the actual gear, is called

View solution

Q. When the frictional force helps to apply the brake, then the brake is said to be self-energizing brake.

View solution

Q. If T is the actual number of teeth on a helical gear and φ is the helix angle for the teeth, then formative number of teeth is written as

View solution

Q. The material generally used for air-craft components is

View solution