Q. An imaginary circle which by pure rolling action gives the same motion as the actual gear, is called

View solution

Q. When the frictional force helps to apply the brake, then the brake is said to be self-energizing brake.

View solution

Q. If T is the actual number of teeth on a helical gear and φ is the helix angle for the teeth, then formative number of teeth is written as

View solution

Q. The material generally used for air-craft components is

View solution

Q. The speed of the sprocket reduces as the chain pitch __________ for a given number of teeth.

View solution

Q. In an oil lubricated journal bearing, the coefficient of friction between the journal and the bearing

View solution

Q. The working of metals above the recrystallisation temperature is known as hot working.

View solution

Q. In a band and block brake, the ratio of tensions on the tight and slack sides of band is given by (where μ = Coefficient of friction between the blocks and the drum, θ = Semi-angle of each block subtending at the centre of drum, and n = Number of blocks)

View solution

Q. The ratio of number of teeth to the pitch circle diameter in millimetres is called circular pitch.

View solution

Q. The washer is generally specified by its

View solution

Q. The taper on key is given on

View solution

Q. The fatigue stress concentration factor is defined as

View solution

Q. A compound cylinder with inner radius 50 mm and outer radius 70 mm is made by shrinking one cylinder on to the other cylinder, The junction radius is 60 mm and the junction pressure is 1.1 N/mm². The maximum hoop stress developed in the inner cylinder is

View solution

Q. A connecting rod subjected to an axial load may buckle in the plane of motion of the connecting rod.

View solution

Q. In a turnbuckle, if one of the rods has left hand threads, then the other rod will have

View solution

Q. When the shaft rotates in anticlockwise direction at high speed in a bearing, it will

View solution

Q. Which of the following statement is wrong for a connecting rod ?

View solution

Q. Which of the following statement is correct ?

View solution

Q. The most important dimension in the design of a nut is

View solution

Q. Factor of safety for fatigue loading is the ratio of

View solution