Question
a.
bottom side only
b.
top side only
c.
on both sides
d.
any side
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The taper on key is given on
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The fatigue stress concentration factor is defined as
View solution
Q. A compound cylinder with inner radius 50 mm and outer radius 70 mm is made by shrinking one cylinder on to the other cylinder, The junction radius is 60 mm and the junction pressure is 1.1 N/mm². The maximum hoop stress developed in the inner cylinder is
View solution
Q. A connecting rod subjected to an axial load may buckle in the plane of motion of the connecting rod.
View solution
Q. In a turnbuckle, if one of the rods has left hand threads, then the other rod will have
View solution
Q. When the shaft rotates in anticlockwise direction at high speed in a bearing, it will
View solution
Q. Which of the following statement is wrong for a connecting rod ?
View solution
Q. Which of the following statement is correct ?
View solution
Q. The most important dimension in the design of a nut is
View solution
Q. Factor of safety for fatigue loading is the ratio of
View solution
Q. The shafts of larger diameter are usually forged and turned to size in a lathe.
View solution
Q. When the pulley or other mating piece is required to slide along the shaft, a __________ sunk key is used.
View solution
Q. In a flange coupling, the bolts are subjected to
View solution
Q. The radial distance from the top of a tooth to the bottom of a tooth is called clearance
View solution
Q. A key made from a cylindrical disc having segmental cross-section, is known as
View solution
Q. The helix angle for double helical gears may be made up to
View solution
Q. Which of the following statement is correct regarding power screws?
View solution
Q. A hollow shaft will transmit a __________ torque than a solid shaft of the same mass and same material.
View solution
Q. A flange coupling is used to connect two shafts
View solution
Q. The algebraic difference between the maximum limit and the basic size is called
View solution
Q. When an open coiled helical compression spring is subjected to an axial compressive load, the stress induced in the wire is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
