Q. A connecting rod subjected to an axial load may buckle in the plane of motion of the connecting rod.

View solution

Q. In a turnbuckle, if one of the rods has left hand threads, then the other rod will have

View solution

Q. When the shaft rotates in anticlockwise direction at high speed in a bearing, it will

View solution

Q. Which of the following statement is wrong for a connecting rod ?

View solution

Q. Which of the following statement is correct ?

View solution

Q. The most important dimension in the design of a nut is

View solution

Q. Factor of safety for fatigue loading is the ratio of

View solution

Q. The shafts of larger diameter are usually forged and turned to size in a lathe.

View solution

Q. When the pulley or other mating piece is required to slide along the shaft, a __________ sunk key is used.

View solution

Q. In a flange coupling, the bolts are subjected to

View solution

Q. The radial distance from the top of a tooth to the bottom of a tooth is called clearance

View solution

Q. A key made from a cylindrical disc having segmental cross-section, is known as

View solution

Q. The helix angle for double helical gears may be made up to

View solution

Q. Which of the following statement is correct regarding power screws?

View solution

Q. A hollow shaft will transmit a __________ torque than a solid shaft of the same mass and same material.

View solution

Q. A flange coupling is used to connect two shafts

View solution

Q. The algebraic difference between the maximum limit and the basic size is called

View solution

Q. When an open coiled helical compression spring is subjected to an axial compressive load, the stress induced in the wire is

View solution

Q. The bending moment M and a torque T is applied on a solid circular shaft. If the maximum bending stress equals to maximum shear stress developed, then M is equal to

View solution

Q. For longitudinal joint in boilers, the type of joint used is

View solution