Q. For longitudinal joint in boilers, the type of joint used is

View solution

Q. A cotter joint is used to transmit

View solution

Q. The maximum efficiency of a square threaded screw is

View solution

Q. The dynamic tooth load is due to

View solution

Q. In a steam engine, the piston rod is usually connected to the crosshead by means of a

View solution

Q. Lewis equation is applied

View solution

Q. A tap bolt has

View solution

Q. According to I.B.R., when the thickness of the boiler shell (t) is less than 8 mm, then the diameter of the rivet hole (d) is obtained by

View solution

Q. A sliding bearing in which although lubricant is present, the working surfaces __________ contact each other at least part of the time, is called boundary lubricated bearing.

View solution

Q. The contact ratio for gears is

View solution

Q. A feather key is generally

View solution

Q. If the tearing efficiency of a riveted joint is 50%, then the ratio of diameter of rivet to the pitch is

View solution

Q. The ratio of circumferential stress to longitudinal stress in a thin cylinder subjected to an internal pressure is

View solution

Q. A riveted joint is a __________ fastening.

View solution

Q. The pressure angle of a cam is the angle between the direction of the follower motion and a normal to the pitch curve.

View solution

Q. A fast and loose pulley drive is used when

View solution

Q. Which of the following screw thread is adopted for power transmission in either direction?

View solution

Q. In the assembly of pulley, key and shaft

View solution

Q. According to I.B.R., the thickness of the boiler shell should not be less than

View solution

Q. A bolt has

View solution