Question
a.
Acme threads
b.
Square threads
c.
Buttress threads
d.
Multiple threads
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Which of the following screw thread is adopted for power transmission in either direction?
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In the assembly of pulley, key and shaft
View solution
Q. According to I.B.R., the thickness of the boiler shell should not be less than
View solution
Q. A bolt has
View solution
Q. The material commonly used for machine tool bodies is
View solution
Q. The power transmitted by a belt drive is maximum when the maximum tension in the belt is __________ the centrifugal tension.
View solution
Q. The largest diameter of an external or internal screw thread is known as
View solution
Q. The gears are termed as medium velocity gears, if their peripheral velocity is
View solution
Q. In the levers of third type, the mechanical advantage is __________ one.
View solution
Q. The edges of the boiler plates are bevelled to an angle of
View solution
Q. Lewis form factor for 14½° composite and full depth involute system is (where T = Number of teeth)
View solution
Q. The stretching in a belt can be controlled by __________ the stress in the belt.
View solution
Q. The distribution of the forces along the length of key fitted in a shaft
View solution
Q. For a shoe brake, the equivalent coefficient of friction is equal to (where μ = Actual coefficient of friction, and θ = Semi-block angle)
View solution
Q. When a cylinder is subjected to a very high internal fluid pressure, the thin cylinder should be used.
View solution
Q. In a full journal bearing, the angle of contact of the bearing with the journal is
View solution
Q. In a flat belt drive, if the slip between the driver and belt is 1 %, between the belt and follower is 3% and driver and follower pulley diameters are equal, then velocity ratio of the drive will be
View solution
Q. A cotter joint is used to connect two __________ rods.
View solution
Q. The product of the diametral pitch and circular pitch is equal to
View solution
Q. If T1 and T2 are the tensions on the tight and slack sides of the belt respectively, and Tc is the centrifugal tension, then initial tension in the belt is equal to
View solution
Q. The smallest diameter of an external or internal screw thread is known as
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
