Q. A flange coupling is used to connect two shafts

View solution

Q. The algebraic difference between the maximum limit and the basic size is called

View solution

Q. When an open coiled helical compression spring is subjected to an axial compressive load, the stress induced in the wire is

View solution

Q. The bending moment M and a torque T is applied on a solid circular shaft. If the maximum bending stress equals to maximum shear stress developed, then M is equal to

View solution

Q. For longitudinal joint in boilers, the type of joint used is

View solution

Q. A cotter joint is used to transmit

View solution

Q. The maximum efficiency of a square threaded screw is

View solution

Q. The dynamic tooth load is due to

View solution

Q. In a steam engine, the piston rod is usually connected to the crosshead by means of a

View solution

Q. Lewis equation is applied

View solution

Q. A tap bolt has

View solution

Q. According to I.B.R., when the thickness of the boiler shell (t) is less than 8 mm, then the diameter of the rivet hole (d) is obtained by

View solution

Q. A sliding bearing in which although lubricant is present, the working surfaces __________ contact each other at least part of the time, is called boundary lubricated bearing.

View solution

Q. The contact ratio for gears is

View solution

Q. A feather key is generally

View solution

Q. If the tearing efficiency of a riveted joint is 50%, then the ratio of diameter of rivet to the pitch is

View solution

Q. The ratio of circumferential stress to longitudinal stress in a thin cylinder subjected to an internal pressure is

View solution

Q. A riveted joint is a __________ fastening.

View solution

Q. The pressure angle of a cam is the angle between the direction of the follower motion and a normal to the pitch curve.

View solution

Q. A fast and loose pulley drive is used when

View solution