Q. The ratio of pitch circle diameter in millimetres to the number of teeth, is called

View solution

Q. According to Indian standard specifications, 100 H6/g5 means that

View solution

Q. Rankine Gordon formula for buckling is valid for

View solution

Q. The angle of twist of shaft is

View solution

Q. A long helical spring having a spring stiffness of 12 kN/m and number of turns 20, breaks into two parts with number of turns 10 each in both the parts. If the two parts are connected in series, then the softness of the resultant spring will be

View solution

Q. The radial distance from the __________ to the clearance circle is called working depth.

View solution

Q. The efficiency of a square threaded screw is maximum if the helix angle is equal to (where φ = Angle of friction)

View solution

Q. In designing thick cylinders, the equation used is

View solution

Q. A double fillet welded joint with parallel fillet weld of length l and leg s is subjected to a tensile force P. Assuming uniform stress distribution, the shear stress in the weld is given by

View solution

Q. Two shafts A and B are made of the same material. The diameter of shaft A is twice as that of shaft B. The power transmitted by the shaft A will be __________ of shaft B.

View solution

Q. Which of the following statement is correct?

View solution

Q. The taper on cotter and slot is made on both the sides.

View solution

Q. Teflon is used for bearings because of

View solution

Q. In designing a flange coupling, the pitch circle diameter of bolts is taken as (where d = Diameter of the shaft)

View solution

Q. The acme threads are usually found on

View solution

Q. A parallel sunk key, made of steel, is equally strong in shearing and crushing.

View solution

Q. In designing a key, it is assumed that the distribution of forces along the length of key

View solution

Q. In a belt drive, the velocity ratio is the inverse ratio of the diameters of driving and driven pulleys.

View solution

Q. In order to have a connecting rod equally strong in buckling about X-axis and Y-axis, the moment of inertia about X-axis should be __________ the moment of inertia about Y-axis.

View solution

Q. The bearing characteristic number in a hydrodynamic bearing depends upon

View solution