Q. The taper on cotter and slot is made on both the sides.

View solution

Q. Teflon is used for bearings because of

View solution

Q. In designing a flange coupling, the pitch circle diameter of bolts is taken as (where d = Diameter of the shaft)

View solution

Q. The acme threads are usually found on

View solution

Q. A parallel sunk key, made of steel, is equally strong in shearing and crushing.

View solution

Q. In designing a key, it is assumed that the distribution of forces along the length of key

View solution

Q. In a belt drive, the velocity ratio is the inverse ratio of the diameters of driving and driven pulleys.

View solution

Q. In order to have a connecting rod equally strong in buckling about X-axis and Y-axis, the moment of inertia about X-axis should be __________ the moment of inertia about Y-axis.

View solution

Q. The bearing characteristic number in a hydrodynamic bearing depends upon

View solution

Q. A jam nut is a locking device in which

View solution

Q. The difference between the upper limit and lower limit of a dimension is called

View solution

Q. The algebraic difference between the actual size and the corresponding basic size is called actual deviation.

View solution

Q. The stiffness of a closely coiled helical spring subjected to an axial load W is equal to (where G = Modulus of rigidity, and n = Number of active coils)

View solution

Q. The average shear stress in the hollow shaft is smaller than the average shear stress in the solid shaft.

View solution

Q. The diameter of knuckle pin in a knuckle joint is usually taken as (where d = Diameter of the rod)

View solution

Q. The design of shafts made of brittle materials is based on

View solution

Q. A locking device extensively used in automobile industry is a

View solution

Q. A key way lowers

View solution

Q. A tapered key which fits in a key way in the hub and is flat on the shaft, is known as

View solution

Q. The included angle for the V-belt is usually

View solution