Question

A triple riveted butt joint with double straps of unequal width is to be designed for a boiler shell. The pitch of the rivets in the outer row is double the pitch in the inner row and zig-zag riveting is proposed. Which of the following statement is correct?

a.

There are four rivets per pitch length, all in double shear

b.

There are four rivets per pitch length, out of which two are in single shear and two are in double shear

c.

There are five rivets per pitch length, all in double shear

d.

There are five rivets per pitch length, out of which four are in double shear and one is in single shear

Posted under Mechanical Engineering

Answer: (d).There are five rivets per pitch length, out of which four are in double shear and one is in single shear

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. A triple riveted butt joint with double straps of unequal width is to be designed for a boiler shell. The pitch of the rivets in the outer row is double the pitch in the inner row...

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The form factor of a helical gear __________ with the increase in the helix angle.

Q. The taper on a rectangular sunk key is

Q. When carbon in the cast iron is in the form of cementite, the cast iron will be of white colour.

Q. A type of brake commonly used in motor cars is a

Q. In a nut and bolt, the diameter at which the ridges on the bolt are in complete touch with the ridges of the corresponding nut, is called pitch diameter.

Q. A double strap butt joint (with equal straps) is

Q. For a bevel gear having the pitch angle θ , the ratio of formative number of teeth (TE) to actual number of teeth (T) is

Q. The modulus of elasticity for mild steel is approximately equal to

Q. A connecting rod subjected to an axial load may buckle with

Q. When the lubricant is forced between the journal and the bearing by external pressure, the bearing is called hydrostatic lubricated bearing.

Q. Crushing resistance required to crush the rivet per pitch length is

Q. Tearing resistance required to tear off the plate per pitch length is (where p = Pitch of rivets, d = Dia. of rivet hole, and σt = Permissible tensile stress for plate material)

Q. The buttress threads have low frictional resistance characteristic of the square threads and have the same strength of V-threads.

Q. The tension on the slack side of the belt is __________ the tension on the tight side of the belt.

Q. The property of a material which enables it to resist fracture due to high impact loads, is called toughness.

Q. The resultant axial load on a bolt depends upon

Q. Wire ropes as compared to cotton ropes

Q. The thickness of key is usually taken equal to one-sixth of diameter of shaft.

Q. Two helical springs of the same material and of equal circular cross-section, length and number of turns, but having radii 80 mm and 40 mm, kept concentrically (smaller radius spring within the larger radius spring), are compressed between two parallel planes with a load W. The inner spring will carry a load equal to

Q. A key is normally made from a cold rolled mild steel bars.

Recommended Subjects

Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!