Q. The tractive force in a locomotive with two cylinders is given by (where c = Fraction of reciprocating parts per cylinder, m = Mass of reciprocating parts, ω = Angular speed of crank, r = Radius of crank, and θ = Angle of inclination of crank to the line of stroke)

View solution

Q. The radial distance of a tooth from the pitch circle to the bottom of the tooth is called

View solution

Q. When the crank is at the inner dead centre, in a reciprocating steam engine, then the velocity of the piston will be

View solution

Q. The frictional torque transmitted in a multi-collared shaft is same as that of a single collared shaft.

View solution

Q. In order to give the primary balance of the reciprocating parts of a multi-cylinder in-line engines,

View solution

Q. The gear train usually employed in clocks is a

View solution

Q. A mass of 1 kg is attached to the end of a spring with a stiffness of 0.7 N/mm. The critical damping coefficient of this system is

View solution

Q. When the two elements of a pair have a surface contact when relative motion takes place and the surface of one element slides over the surface of the other, the pair formed is known as a

View solution

Q. The two elements of a pair are said to form a __________ when they permit relative motion between them.

View solution

Q. When the axes of the shafts, over which the gears are mounted, move relative to a fixed axis, then the train is known as reverted gear train.

View solution

Q. In under damped vibrating system, the amplitude of vibration

View solution

Q. The ratio of the actual damping coefficient to the critical damping coefficient is called damping factor.

View solution

Q. When a body moves with simple harmonic motion, the product of its periodic time and frequency is equal to

View solution

Q. In a vibrating system, if the actual damping coefficient is 40 N/m/s and critical damping coefficient is 420 N/m/s, then logarithmic decrement is equal to

View solution

Q. In a coupling rod of a locomotive, each of the four pairs is a __________ pair.

View solution

Q. The sliding pairs, turning pairs and screw pairs form lower pairs.

View solution

Q. When a particle moves round the circumference of a circle of radius r with ω rad/s, then its maximum acceleration is ω²r.

View solution

Q. A shaft has an attached disc at the centre of its length. The disc has its centre of gravity located at a distance of 2 mm from the axis of the shaft. When the shaft is allowed to vibrate in its natural bow-shaped mode, it has a frequency of vibration of 10 rad/s. When the shaft is rotated at 300 r.p.m., it will whirl with a radius of

View solution

Q. The swaying couple is maximum or minimum when the angle of inclination of the crank to the line of stroke (θ) is equal to

View solution

Q. The pressure angle of a cam is the angle between the direction of the follower motion and a normal to the

View solution