Q. The module is the reciprocal of diametral pitch.

View solution

Q. If the controlling force line for a spring controlled governor when produced intersects the Y-axis at the origin, then the governor is said to be

View solution

Q. In a reciprocating steam engine, when the crank has turned from inner dead centre through an angle θ, the angular acceleration of the connecting rod is given by

View solution

Q. If the controlling force line for a spring controlled governor when produced intersects the Y-axis above the origin, then the governor is said to be unstable.

View solution

Q. The inversion of a mechanism is

View solution

Q. The coefficient of fluctuation of energy is the ratio of maximum energy to the minimum energy.

View solution

Q. When the nature of contact between the elements of a pair is such that it can only slide relative to the other, the pair is known as a

View solution

Q. The velocity of a particle moving with simple harmonic motion, at any instant is given by (where ω = Displacement of the particle from mean position)

View solution

Q. The velocity of piston in a reciprocating steam engine is given by (where ω = Angular velocity of crank, r = Radius of crank pin circle, θ = Angle turned by crank from inner dead centre, and n = Ratio of length of connecting rod to the radius of crank)

View solution

Q. Which of the following is a higher pair?

View solution

Q. When the belt is stationary, it is subjected to some tension known as initial tension. The value of this tension is equal to the

View solution

Q. In a force-closed pair, the two elements of a pair are not held together mechanically.

View solution

Q. Maximum fluctuation of energy in a flywheel is equal to (where I = Mass moment of inertia of the flywheel, E = Maximum fluctuation of energy, CS = Coefficient of fluctuation of speed, and ω = Mean angular speed = )

View solution

Q. The coriolis component of acceleration acts

View solution

Q. The primary unbalanced force is maximum __________ in one revolution of the crank.

View solution

Q. The instantaneous centres which vary with the configuration of mechanism, are called

View solution

Q. The displacement of the reciprocating roller follower, when it has contact with the straight flanks of the tangent cam, is given by (where r1 = Minimum radius of the cam, r2 = Radius of the roller follower, and θ = Angle turned by the cam from the beginning of the follower displacement)

View solution

Q. In considering friction of a V-thread, the virtual coefficient of friction (μ1) is given by

View solution

Q. The wear of bearing is proportional to velocity and pressure.

View solution

Q. The maximum or minimum value of the swaying couple is

View solution