Q. When two non-intersecting and non-coplaner shafts are connected by gears, the arrangement is known as helical gearing.

View solution

Q. When the elements of a pair are kept in contact by the action of external forces, the pair is said to be a

View solution

Q. The centrifugal tension in belts

View solution

Q. In a Hartnell governor, the compression of the spring is __________ the lift of the sleeve.

View solution

Q. The controlling force diagram for a spring controlled governor is a curve passing through the origin.

View solution

Q. The lower pairs are __________ pairs.

View solution

Q. The arrangement is called bevel gearing, when two __________ are connected by gears.

View solution

Q. The static balancing is satisfactory for low speed rotors but with increasing speeds, dynamic balancing becomes necessary. This is because, the

View solution

Q. The maximum fluctuation of speed is the

View solution

Q. A single degree of freedom system is given by , with usual notations. It represents

View solution

Q. In a Hartnell governor, the lift of the sleeve is given by (where r1 and r2 = Max. and min. radii of rotation, x = Length of ball arm of the lever, and y = Length of sleeve arm of the lever)

View solution

Q. When a mechanism is required to transmit power or to do some particular type of work, then it becomes a machine.

View solution

Q. The transmissibility, for all values of damping factor, will be less than unity, if ω/ωn is

View solution

Q. When a shaking force is transmitted through the springs, damping becomes detrimental when the ratio of its frequency to the natural frequency is greater than

View solution

Q. When the nature of contact between the elements of a pair is such that it can turn or revolve about a fixed axis, the pair is known as a rolling pair.

View solution

Q. Creep in belt drive is due to

View solution

Q. Which of the following statement is wrong?

View solution

Q. A watt's governor can work satisfactorily at speeds from

View solution

Q. The displacement of a flat-faced follower when it has contact with the flank of a circular arc cam, is given by (where R = Radius of flank, r1 = Minimum radius of the cam, and θ = Angle turned through by the cam)

View solution

Q. The contact ratio is the ratio of

View solution