Q. Which of the following statements regarding laws governing the friction between dry surfaces are correct?

View solution

Q. The frictional torque transmitted in a conical pivot bearing, considering uniform wear, is

View solution

Q. A combination of kinematic pairs, joined in such a way that the relative motion between the links is completely constrained, is called a

View solution

Q. A link or element need not to be a rigid body, but it must be a resistant body.

View solution

Q. The velocity of the belt for maximum power is (where m = Mass of the belt in kg per metre length)

View solution

Q. In a band and block brake, the ratio of tensions on tight side and slack side of the band is (where μ = Coefficient of friction between the blocks and the drum, θ = Semi-angle of each block subtending at the centre of drum, and n = Number of blocks)

View solution

Q. When there is a reduction in amplitude over every cycle of vibration, then the body is said to have

View solution

Q. In full depth involute system, the smallest number of teeth in a pinion which meshes with rack without interference is

View solution

Q. A system in dynamic balance implies that

View solution

Q. The example of completely constrained motion is a

View solution

Q. In involute gears, the pressure angle is

View solution

Q. A shaft carrying three rotors will have

View solution

Q. Which of the following is used to control the speed variations of the engine caused by the fluctuations of the engine turning moment?

View solution

Q. The ratio of driving tensions for rope drive is same as that of V-belt drive.

View solution

Q. A Hartnell governor is a

View solution

Q. Frequency of vibrations is usually expressed in

View solution

Q. The relation between number of pairs (p) forming a kinematic chain and the number of links (l) is

View solution

Q. The ratio of the number of teeth to the pitch circle diameter in millimetres, is called

View solution

Q. The ratio of the pitch circle diameter in millimetres to the number of teeth, is called circular pitch.

View solution

Q. The rotating shafts tend to vibrate violently at whirling speeds because

View solution