Q. Which of the following is an inversion of a double slider crank chain?

View solution

Q. The unbalanced force due to revolving masses

View solution

Q. Which of the following statement is correct for gears ?

View solution

Q. In a screw jack, the effort required to lift the load W is given by (where α = Helix angle, and φ = Angle of friction)

View solution

Q. In order to facilitate starting of locomotive in any position, the cranks of a locomotive with two cylinders, are placed at

View solution

Q. The coriolis component of acceleration leads the sliding velocity by

View solution

Q. The length of a simple pendulum which gives the same frequency as the compound pendulum, is

View solution

Q. Which of the following is a spring controlled governor?

View solution

Q. The engine of an aeroplane rotates in clockwise direction when seen from the tail end and the aeroplane takes a turn to the right. The effect of gyroscopic couple on the aeroplane will be to dip the nose and raise the tail.

View solution

Q. At the nodal point in a shaft, the amplitude for torsional vibration will be

View solution

Q. When a body is subjected to transverse vibrations, the stress induced in a body will be

View solution

Q. The magnitude of linear velocity of a point B on a link AB relative to point A is (where ω = Angular velocity of the link AB)

View solution

Q. A slender shaft supported on two bearings at its ends carries a disc with an eccentricity e from the axis of rotation. The critical speed of the shaft is Nc. If the disc is replaced by a second one of same mass but mounted with an eccentricily 2 e, then the critical speed of the shaft in the second case is

View solution

Q. The mechanism in which two are turning pairs and two are sliding pairs, is called a

View solution

Q. In a multiple V-belt drive, all the belts should stretch at the same rate.

View solution

Q. In a reciprocating engine, usually __________ of the reciprocating masses are balanced.

View solution

Q. The cam follower generally used in air-craft engines is

View solution

Q. In a locomotive, the maximum magnitude of the unbalanced force along the perpendicular to the line of stroke, is known as

View solution

Q. If ω/ωn is very low for a body vibrating under steady state vibrations, the phase angle for all values of damping factors, will tend to approach

View solution

Q. The factional torque for square thread at the mean radius r while raising load W is given by

View solution