Q. The equivalent length of a simple pendulum which gives the same frequency as a compound pendulum is

View solution

Q. The component of the acceleration, perpendicular to the velocity of the particle, at the given instant is called

View solution

Q. The maximum efficiency of spiral gears is (where θ = Shaft angle, and φ = Friction angle)

View solution

Q. When the crank is at the inner dead centre, in a reciprocating steam engine, then the acceleration of the piston will be

View solution

Q. When the tip of a tooth undercuts the root on its mating gear, it is known as interference.

View solution

Q. Under logarithmic decrement, the amplitude of successive vibrations are

View solution

Q. The efficiency of a screw jack is maximum, when (where α = Helix angle, and φ = Angle of friction)

View solution

Q. A fixed gear having 200 teeth is in mesh with another gear having 50 teeth. The two gears are connected by an arm. The number of turns made by the smaller gear for one revolution of arm about the centre of bigger gear is

View solution

Q. In a cone pulley, if the sum of radii of the pulleys on the driving and driven shafts is Constant, then

View solution

Q. The critical speed of a shaft depends upon its

View solution

Q. Which of the following mechanism is an approximate straight line motion mechanism?

View solution

Q. A shaft carrying two rotors at its ends will have

View solution

Q. When a mass of a critically damped single degree of freedom system is deflected from its equilibrium position and released, then it will

View solution

Q. The friction experienced by a body, when at rest, is known as static friction.

View solution

Q. The instantaneous centre of a rigid thin disc rolling on a plane rigid surface is located at

View solution

Q. In a flat collar pivot bearing, the moment due to friction is proportional to

View solution

Q. The coefficient of fluctuation of speed is __________ of maximum fluctuation of speed and the mean speed.

View solution

Q. A rigid body, under the action of external forces, can be replaced by two masses placed at a fixed distance apart. The two masses form an equivalent dynamical system, if

View solution

Q. When two pulleys are connected by means of a cross belt drive, then both the pulleys will rotate in __________ directions.

View solution

Q. The pitching of a ship produces forces on the bearings which act __________ to the motion of the ship.

View solution