Q. The low pressure acetylene is produced at the welding site by the chemical reaction between water and calcium carbonate.

View solution

Q. The fullers are used

View solution

Q. The cold chisels are made by

View solution

Q. The property of sand due to which it evolves a great amount of steam and other gases is called

View solution

Q. The centrifugal casting method, is used for casting articles of

View solution

Q. Galvanising is a

View solution

Q. The ferrous metals require more machining allowance than non-ferrous metals.

View solution

Q. In a four high rolling mill, there are four rolls out of which

View solution

Q. When a pattern is made in three parts, the bottom part is known as a cope.

View solution

Q. In __________ welding, the weld may be made either from left to right or from right to left.

View solution

Q. Metal patterns are used for

View solution

Q. The instrument which has all the features of try-square, bevel protractor, rule and scriber, is

View solution

Q. When a hole or cavity to be cored is not in line with the parting surface, then a __________ is used.

View solution

Q. The bloom is smaller than a billet.

View solution

Q. In average work, the tolerance produced by investment casting method is

View solution

Q. In order to cut mild steel, the cutting angle of chisel should be

View solution

Q. The operation of straightening a curved sheet metal, is known as

View solution

Q. The correct sequence for preparing a billet for extrusion process is pickling, alkaline cleaning, phosphate coating and lubricating with reactive soap.

View solution

Q. Tandem drawing of wires and tubes is necessary because

View solution

Q. In a __________ , both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram.

View solution