Q. The shrinkage allowance for cast iron pattern is

View solution

Q. An oxidising flame is obtained when equal volumes of oxygen and acetylene are supplied.

View solution

Q. A neutral flame is obtained by supplying

View solution

Q. An oxidising process used for aluminium and magnesium articles is called

View solution

Q. For welding plates of thickness less than 5 mm, its edges

View solution

Q. In order to check the clearance between two mating surfaces, a __________ gauge should be used.

View solution

Q. When the weld is made from left to right, it is known as back-hand welding.

View solution

Q. The current in electric resistance welding can be regulated by

View solution

Q. In a cold chamber die casting machine, only non-ferrous alloys with __________ are casted.

View solution

Q. A mortise gauge is a

View solution

Q. In spot welding, the spacing between two spot weld should not be less than

View solution

Q. Aluminium is the best material for making patterns because it is

View solution

Q. Gagger is used for cleaning the moulding sand.

View solution

Q. In sheet metal work, the cutting force on the tool can be reduced by

View solution

Q. In order to get uniform thickness of the plate by rolling process, one provides

View solution

Q. Cutting and forming operations can be performed in a single operation in a

View solution

Q. The teeth of hacksaw blade are bent

View solution

Q. In a cold chamber die casting machine, a measured quantity of molten metal is brought in a ladle from the melting pot to a chamber and forced into the closed die-section by applying hydraulic pressure upon the plunger.

View solution

Q. For cutting brass, the hacksaw blade should have __________ teeth per 25 mm.

View solution

Q. A casting defect which occurs near the ingates as rough lumps on the surface of a casting is known as

View solution