Q. Cutting and forming operations can be performed in a single operation in a

View solution

Q. The teeth of hacksaw blade are bent

View solution

Q. In a cold chamber die casting machine, a measured quantity of molten metal is brought in a ladle from the melting pot to a chamber and forced into the closed die-section by applying hydraulic pressure upon the plunger.

View solution

Q. For cutting brass, the hacksaw blade should have __________ teeth per 25 mm.

View solution

Q. A casting defect which occurs near the ingates as rough lumps on the surface of a casting is known as

View solution

Q. Loam sand is a mixture of

View solution

Q. A three high rolling mill consists of three rolls placed one above the other. Which of the following statement is correct?

View solution

Q. The oxy-acetylene gas used in gas welding produce a flame temperature of

View solution

Q. Metal patterns require __________ draft allowance than wooden patterns.

View solution

Q. For gas welding, the presure desired at the welding torch for acetylene is

View solution

Q. Spot welding is used for welding

View solution

Q. Thermit welding is often used in

View solution

Q. The directional solidification in casting can be improved by using

View solution

Q. A sand employed on the faces of the pattern before moulding, is called

View solution

Q. The material which can be best cut with oxygen cutting process is

View solution

Q. In fore-hand welding, the weld is made

View solution

Q. In spot welding, the distance between the nearest edge of the plate and centre of weld should be equal to

View solution

Q. Thermit, used in thermit welding, is a mixture of

View solution

Q. The width of slot cut by a hacksaw blade is __________ the width of the blade.

View solution

Q. The casting method adopted for ornaments and toys of non-ferrous alloys, is

View solution