Question
a.
0.02 m inclined upwards
b.
0.04 m inclined downwards
c.
0.04 m inclined upward
d.
none of these.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A dumpy level was set up at the midpoint between two pegs A and B, 50 m apart and the staff readings at A and B were 1.22 and 1.06. With the level set up a A, the readings at A and...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. If the rate of gain of radial acceleration is 0.3 m per sec³ and full centrifugal ratio is developed. On the curve the ratio of the length of the transition curve of same radius on road and railway, is
View solution
Q. The angle between two plane mirrors of optical square, is
View solution
Q. The latitude of a traverse leg is obtained by multiplying its length by
View solution
Q. For a curve of radius 100 m and normal chord 10 m, the Rankine's deflection angle, is
View solution
Q. A uniform slope was measured by the method of stepping. If the difference in level between two points is 1.8 m and the slope distance between them is 15 m, the error is approximately equal to
View solution
Q. Which one of the following procedures for getting accurate orientation is the most distinctive feature of the art of plane tabling
View solution
Q. A clinometer is used for
View solution
Q. Diurnal variation of magnetic declination is
View solution
Q. The 'fix' of a plane table from three known points, is good, if
View solution
Q. The construction of optical square is based, on the principle of optical
View solution
Q. If the smallest division of a vernier is longer than the smallest division of its primary scale, the vernier is known as
View solution
Q. Cross-staff is used for
View solution
Q. The 'point of curve' of a simple circular curve, is
View solution
Q. For orientation of a plane table with three points A, B and C, Bessel's drill is
View solution
Q. The minimum range for sliding the focusing lens in the internal focusing telescope for focusing at all distances beyond 4 m is
View solution
Q. If a tacheometer is fitted with an anal-latic lens
View solution
Q. Volume of the earth work may be calculated by
View solution
Q. Which one of the following mistakes/errors may be cumulative + or - :
View solution
Q. The orthographical projection of a traverse leg upon the reference meridian, is known as
View solution
Q. The whole circle bearing of a line is 290°. Its reduced bearing is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
