Q. Which of the following introduces an error of about 1 in 1000 if 20 m chain is used

View solution

Q. In a lemniscate curve the ratio of the angle between the tangent at the end of the polar ray and the straight, and the angle between the polar ray and the straight, is

View solution

Q. Ranging in chain survey means

View solution

Q. Accurate measurement of deflection angles with a transit not properly adjusted may be made by

View solution

Q. If whole circle bearing of a line is 120°, its reduced bearing is

View solution

Q. Greater accuracy in linear measurements, is obtained by

View solution

Q. From any point on the surface with a given inclination

View solution

Q. Angles to a given pivot station observed from a number of traverse stations when plotted, the lines to the pivot station intersect at a common point

View solution

Q. Reduced bearing of a line is an angle between

View solution

Q. While measuring with a metallic tape of 30 m length pull should be applied

View solution

Q. With usual notations, the expression V²/gR represents

View solution

Q. An angle of deflection right, may be directly obtained by setting the instrument to read

View solution

Q. The method of finding out the difference in elevation between two points for eliminating the effect of curvature and refraction, is

View solution

Q. Transition curves are introduced at either end of a circular curve, to obtain

View solution

Q. The horizontal angle between true meridian and magnetic meridian, is known

View solution

Q. For preparation of a contour plan for a route survey

View solution

Q. Flint glass

View solution

Q. The zero of the graduated circle of a prismatic compass is located at

View solution

Q. The ratio of the linear displacement at the end of a line, subtended by an arc of one second to the length of the line, is

View solution

Q. The co-ordinate of a point measured perpendicular to the parallel, is called

View solution